Mask welding machine with low production cost

Welding Machine safety operation rules
1. Preparation before welding
(1) The electric welding machine should be placed in a ventilated and dry place and placed stably.
(2) Check that the welding mask should be free of light leakage and damage. Welders and auxiliary personnel should wear the prescribed labor protection equipment, and set up light shields to isolate the radiant heat emitted by the welding parts.
(3) The welding machine, welding tongs, power cord and all joint parts should be connected reliably, with good insulation, and overheating at the wiring should not be allowed. The power terminals should not be exposed, and should be wrapped with insulating tape.
(4) The length of the wire between the welding machine and the welding tongs shall not exceed 30M, and shall not exceed 50M if it is specially required. If the wire is damp or broken, it should be replaced immediately.
(5) AC welding machine
①The wiring of the primary and secondary lines should be accurate. The input voltage should comply with the equipment regulations, and it is strictly forbidden to touch the live part of the initial line.
②The copper plate connecting the secondary tap must be pressed tightly, and the terminal should have a washer.
(6) Before using the DC welding machine, the dirt on the commutator should be cleaned to keep the commutator in good contact with the brushes.

Mask Welding Machine specifications：

• Mask welding machine power: 2000W
• Ultrasonic frequency: 20KHz
• Working efficiency of electric welding machine: 15-20PCS/min
• The main work of the Automatic welding machine: Welding of earbands for disposable masks
• Welding machine air pressure: 4KG/cm²
• Machine power requirements: 50/60Hz, 220V
• Welding machine weight: 115KG
• Mask welding machine size (cm): 110*80*140

This mask welding machine is mainly used for disposable earband mask welding, which can quickly weld the earband for you, and can weld 15-20PCS per minute, saving labor costs!